TM 10-3530-207-14
2-8.
ASSEMBLY AND PREPARATION FOR USE - continued.
h.
Assembly of Clothing Sewing Machine Table - continued.
(22) Adjust the belt so that it is not stretched but yet not so loose that the machine does not operate.
Refer to paragraph 3-10 for belt adjustment procedures.
NOTE
The belt guard is placed below the bobbin winder and is held on by one machine screw.
(23) Install belt guard (6), bobbin winder (7) to table (3) and secure with two machine screws (8).
Adjust for 1/8 inch (3 mm) clearance between bobbin winder pulley and belt (5).
(24) Install thread unwinder base (9) to table (3) and secure with three machine screws (8).
(25) Install rod (10) and nut (11) to thread underwinder base (9).
(26) Install cone rest (12) on rod (10). Secure cone rest (12) by tightening setscrew (13).
(27) Install two posts (14), two lockwashers (15) and two nuts (16) to cone rest (12).
(28) Install two pads (17), two felts (18) and two thread clips (19) to posts (14).
(29) Install thread guides (20) to top post (21) and secure with clip (22), washer (23) and wingnut (24).
(30) Install top post (21) to rod (10) and secure by tightening nut (25).
2-47
