TM 10-4510-201-24P
SECTION I
INTRODUCTION
1. Scope
a. This manual lists repair parts required, for the
3. Explanation of Columns
performance of organizational, direct support, general
The following provides an explanation of columns in the
support, and depot maintenance of the Bath Unit.
tabular lists in Sections II through V.
b. Repair parts listed represent those authorized
a. Source, Maintenance, and Recoverability Codes
for use at indicated maintenance levels and will be
(SMR).
requisitioned (on an "as required" basis until stockage is
(1) Source code indicates the source for the
justified by demand in accordance with AR 735-35 or AR
listed items. Source Codes are:
710-2).
Code
Explanation
P
Repair Parts supplied from the GSA/DSA, or
2. General
This Repair Parts and Special Tools List is divided into
Army supply system, and authorized for use at
the following sections:
indicated maintenance levels.
P2
Repair Parts 'which are procured and stocked or
item number sequence, of repair parts authorized at the
insurance purposes because the combat or
organizational level for the performance of maintenance,
military essentiality of the end item dictates tat
including those items which must be removed for
a minimum quantity be available in the supply
replacement of the authorized item. Items, except kits
system.
and sets, are listed by assembly group in top down
M
Repair Parts which are not procured or stocked,
breakdown sequence. Repair parts kits and sets are
as such, in the supply system but are to be
listed separately as Group 4 at the end of this Section
manufactured at indicated maintenance levels.
without regard to the assembly group to which they
A
Assemblies which are not procured or stocked
belong.
as such, but are made up of two or more units.
b. Special Tools, Test and Support Equipment -
Such component units carry individual stock
Section III. (Not Applicable).
numbers and descriptions, are procured and
stocked separately and can be assembled to
item number sequence, of the repair parts authorized for
form the required assembly at indicated
the performance of maintenance at the direct support,
maintenance levels.
general support, and depot levels, including those items
X
Parts and assemblies that are not procured or
which must be removed for replacement of the
stocked because the failure rate is normally
authorized, item. Items, except kits and sets, are listed
below that of the applicable end item or
by assembly group in top down breakdown sequence.
component.
The failure of such part or
Repair parts kits and sets are listed separately as Group
assembly should result in retirement of the
4 at the end of this section without regard to the
end item from the supply system.
assembly group to which they belong.
X1
Repair Parts which are not procured or stocked.
d. Special Tools, Test and Support Equipment
The requirement for such items will be filled by
Section V. (Not applicable.)
the next higher assembly or component.
e. National Stock Number and Reference Number
X2
Repair Parts which are not stocked and have no
foreseen
mortality.
The
indicated
ascending numerical sequence, followed by a list of
maintenance category requiring such repair
reference numbers appearing in all listings, in ascending
parts will attempt to obtain the parts through
alpha-numeric sequence, cross-referenced to the
cannibalization
or
salvage,
if
not
illustration figure and item number.
obtainable
through
cannibalization
NOTE
Items not
illustrated are
cross-
referenced
to
assembly
group
number.
iii
