TM 10-4510-207-14
OPERATING INSTRUCTIONS
SECTION I DESCRIPTION AND USE OF OPERATOR'S CONTROL AND
INDICATORS
Refer to Figure 21.
2.1. SUPPY PUMP SWITCH.
The supply pump switch (1) controls power to the supply pump as well as overload protection for the motor.
Place the switch in the ON position for operation and the OFF position when not in use. If the motor overloads,
the switch will move to a mid-way TRIPPED position and power will be interrupted. If the switch is in the
TRIPPED position, it must be switched to OFF then ON to reset it.
2.2. DIAPHRAGM (DRAIN) PUMP SWITCH.
The diaphragm (drain) pump switch (2) control power to he diaphragm (drain) pump as well as providing
overload protection for the motor. Place the switch in the ON position and the OFF position when not id use. If
the motor overloads, the switch will move to a mid-way TRIPPED position and power will be interrupted. If the
switch is in the TRIPPED position, it must be switched to OFF then ON to reset it.
2.3. TEMPERATURE REGULATOR.
The temperature regulator (3) has a manually adjusted control knob that can be set to deliver the desired water
temperature to the shower stall. Turning the control knob counterclockwise increases the delivered water
temperature and clockwise decreases it.
2.4. TEMPERATURE GAUGE.
The temperature gauge (4) indicates the water temperature being sent to the shower stall. Observe this indicator
whenever adjusting the temperature regulator.
2-1
