TM 10-4510-207-14
3.3. SHOWER COVER REPLACEMENT.
This task covers: a. Removal b. Installation
INITIAL SETUP
Equipment Conditions:
Personnel Required:
Three
Shower Facility not in use.
System shut down and pressure relieved,
Refer to figure 3 -3.
a. Removal.
(1)
Release quick disconnect coupling (s) (1), then separated and remove supply hose (s) (2) as necessary.
(2)
Remove door panel (3) is an end shower cover (4) is being replaced.
(3)
Release hook and pile fastener strips (5) securing shower cover (4) to vertical supports (6 and 7). Remove
vertical support (6).
(4)
Release hook and pile strips securing shower cover (4) to shower base (80.
(5)
Release hook and pile fastener strips securing facing shower covers (4) to each other.
(6)
Release pile and fastener strips (9), then from the inside, lift top frame assembly (10) off vertical
supports (7) with shower cover (4) attached.
(7)
Release hook and pile fastener strips (11) and remove shower cover (4) from top frame assembly
(10).
b. Installation.
(1) Place shower cover (4) over top frame assembly (10) and carefully guide three outer legs through
openings in back
of cover. Secure shower cover to top frame assembly with attached hook and pile fastener strips (9).
(2) From the inside, lift top frame assembly (10), with shower cover (4) attached and install onto
vertical supports (7). Note that the two outer supports are on the outside of the cover.
(3) Install vertical support (6).
(4) Secure shower cover (4) to vertical supports (6 and 7) using attached hook and pile fastener strips (5).
(5) Secure shower cover (4) to inside of shower base (8) using attached hook and pile fastener strips.
(6) Secure facing top frame assemblies (10) to each other using attached hook and pile fastener strips (9)
(7) Secure facing shower covers (4) to each other using attached hook and pile fastener strips.
3-6
