TM 10-4510-207-14
(2) System Power Cable Assembly.
NOTE
Gasket is supplied only with new box cover.
(a) Remove four screws (7), cover (8), and gasket (9).
(b) Tag and disconnect leads on cables (10, 11, and 12) inside box (13).
(c) Loosen three cable connectors (14) and remove cables (10, 11, and 12). Remove cable
connectors from box (13).
(d) Remove heat shrink tubing (15) and crimp terminals (16) as necessary.
(e) Slip one cover cap (17) off each cable (10, 11, and 12).
(f) Remove plugs (3 and 4) from cables (10 and11) and connector (2) from cable (12).
(g) Replace any damaged or missing components.
c.
Assembly.
(1) Input Power Cable Assembly.
(a) Check that any damaged or missing components have been replaced.
(b) Install ID strap (6) marked NEUTRAL onto white lead and ID strap marked GROUND onto
green lead.
(c) Check that insulation has been stripped form cable (18) as illustrated then install connector (1).
(d) Slipcover cap (5) onto Cable (18) and over connector (1).
(2) System Power Cable Assembly.
(a) Check that any damaged or missing components have been replace.
(b) Check that insulation has been stripped from cables (10,11, and 12) as illustrated then install
connector (2) onto cable (12) and plugs (3 and 4) onto cables (10 and 11).
(c) Slip one cover cap (17) onto each cable (10,11, and 12) and cover connector (2) and plugs (3 and 4).
5-3
