TM 10-4510-207-14
5.1. POWER CABLE ASSEMBLIES REPAIR. CONTINUED
d.
Install heat shrink tubing (15) and crimp terminals (16) as necessary.
(1) To install a crimp terminal on the end of a wire, be sure that - inch (0.6 1.3 cm) of insulation is
stripped from the end of the wire. Insert wire end into the shank of the terminal then crimp the shank
tightly onto the wire.
(2) To install heat shrink tubing. Slide the tubing over the wire before making the connection. After the
connection is made, slide the tubing over the connection point and heat to shrink in place.
e.
Apply sealing compound to threaded and of each cable, connector (14) then install the three cable
connectors into box (13).
f.
Install cables (10,11, and 12) into cable connectors (14) as illustrated. Tighten cable connectors onto
cables.
g.
Connect leads on cables (10, 11, and 12) inside box (13) using tags. Install heat shrink tubing as
necessary to insulate connection points.
h.
Apply sealing compound to threads of four screws (7) then install gasket (9), cover (8), and the four
screws.
5-4
