TM 10-4510-209-13&P
0047 00
8. Remove two screws (7) holding outlet (1) to container.
9. Pull outlet (1) out enough to provide access to wire connections.
10. Tag and disconnect wires (8), and remove outlet (1).
11. Use a multimeter set to read ohms (Ω) to test for continuity in each outlet (1). If no continuity exists
between poles (9), replace outlet. If continuity exists between any pole and ground, replace outlet.
12. Reconnect wires (8) as tagged.
13. Install and tighten two screws (7) holding outlet (1) to container.
14. Place faceplate (6) into position and retain with screw (5).
15. Install marine caulking around faceplate (6).
16. Reconnect power, and repeat steps 2., 3., and 4.
1
3
3
8
7
1
2
9
4
5
6
0047 00-2
