TM 10-7360-226-13&P
0006 00
CONTAINERIZED KITCHEN (WITH TRAILER)
OPERATION UNDER USUAL CONDITIONS
8. Roll up the window flap behind the sink location and secure it with the strap provided.
9. Position the sink assembly in its operational position and lock the front casters.
10. If it will not be needed to fill the steam table or tray pack heater, repack the 25-ft water supply
hose on the bottom shelf of the sink assembly.
11. Unstrap the mobile warming cabinet and move it to its operational position in the food
preparation wing, against the positioning rail on the floor. Place it as tightly in the corner as
possible and lock the front casters. Connect its power cord to the marked receptacle on the
ceiling raceway in the center core of the kitchen.
12. Unstrap the pan rack and temporarily move it and the steam table pans to a convenient
location out of the way.
13. Unstrap and move the oven assembly to approximately its operational location in the food
preparation wing. Inside the oven, unstrap the work table drawers and retrieve the chimney
pipe. Attach it to the outlet of the oven fan, oriented so the outlet points down. The drawers
may be left inside the oven until they are called for later in this work package.
14. Carefully guiding the chimney pipe through the opening in the wall, locate the oven assembly
against the positioning rail on the floor. Lock the front casters.
15. Uncoil the fuel line on right side of the oven assembly. Lead it along the floor against the end
wall, remove the dust caps, and attach it to the fuel supply fitting at the base of the mechanical
room wall.
16. Uncoil the longer of the two 24 VDC power cables on the left side of the oven assembly. Lead
it up the arch and plug it into its marked receptacle on the ceiling raceway. Similarly, uncoil the
120 VAC power cable on top of the oven assembly, route it up the arch, and plug it into its
marked receptacle on the ceiling raceway. Secure both cables in place using the hook and
loop straps on the 24 VDC cable.
CAUTION
Check to be sure the MBU is properly installed in the oven base. The top of the MBU
should be flush with the bottom of the oven, and the hinged flap above the MBU should be
down.
17. Move the pan rack to its operational position to the right of the oven assembly.
18. Retrieve the appliance control box from its storage location in the sink base. Hang it from the
horizontal spacer bar just to the right of the center arch. Lead the power cable up along the
arch to its marked receptacle on the ceiling raceway. Plug in the cable and secure it in place
by wedging it between the shelter arch and the fabric.
19. Verify that the four switches on the appliance control box are OFF. Plug the power cables for
the water pump (short cable) and water heater (long cable) into their respective outlets on the
bottom of the box.
CAUTION
Ensure that no power cables are touching the tray pack heater or the oven.
They could become damaged and result in a fire or shock hazard.
20. Secure the excess lengths of cable between the fabric and the spacer bar.
0006 00-19
Change 2
