TM 10-8400-203-2312-7. REPAIR AND MAINTENANCE OF HARNESS (NSN 8465-00-753-7548) – ContinuedFigure 12-23. Replacement details, keeper pin strap.f. Replacing Hardware.(1)(2)Keeper pin. Replace a bent, sprung, burred or nicked keeper pin with a serviceable like item fromstock. Open damaged pin, and remove it from keeper pin strap. Thread strap loop into place betweenforks of new pin.Cable and conduit assembly.(a)(b)1.Removal. Refer to Figure 12-24, unscrew push-pull actuator assembly from release fasteners,and withdraw assembly through quick-release retaining loop.Installation.Position a 20 x 10 inch (50.8 x 25.4 cm) preformer, using a rigid wooden or paperboard box, in thetop part of the top part of harness and secure with two “F” web straps as shown in Figure 12-24.Failure to correctly position release knob could result in a safety hazard. Ifthe knob is in the up position it could interfere with the parachutist’sreserve parachute.12-34
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business