12-7. REPAIR AND MAINTENANCE OF HARNESS (NSN 8465-00-753-6548) – Continued
2. With the words “Pull to Release” on the actuator knob facing up as shown in Figure 12-24, insert the push-
pull actuator assembly through the retaining loops on both sides of the harness and attach to release
fasteners with nuts. Remove preformer.
(3)
NOTE
When tightening the nuts, assure that the release fasteners are not twisted
away from the harness. When the nuts are fully tightened the actuator knob
should be in position shown in Figure 12-24.
Other items of hardware. Replace other damaged items of hardware on the harness with serviceable
like items from stock. Do not attempt to straighten bent hardware or otherwise repair cracked or
broken hardware. When it is necessary to cut any stitching to remove damaged hardware from
webbing, replace hardware and webbing following procedures in the appropriate section of subpara-
graph e above. Do not restitch the webbing.
12-35
TM 10-8400-203-23
