TM 10-8400-203-23
19-4. GENERAL–Continued
Suspension:
Remove the six mounting screws and A-nuts; remove the
suspension. Replace new suspension and hardware if nec-
essary by lining up the holes in the helmet, making sure the
drawstring pull tab is at the rear of the helmet. Insert the
A-nut (peak of A toward the rim) through the holes and
replace the six screws.
Chin Strap:
Remove the screws and remove the chin strap. Replace
new chin strap as shown making sure the snap fastener is
on the left side of the helmet as worn.
Figure 19-1. Remove & Replace Suspension & Chin Strap.
19-2
