TM 10-8400-203-23
23-7. REPAIR OF COAT, BODY ARMOR SYSTEM FOR EOD—Continued
I
a. Restitching The Inner And Outer Covers.
(1) Remove all loose or broken threads from the seams to be restitched.
(2) Use the types of stitches, thread size and stitches per inch as shown in Table 23-2 below.
b. Replacement Of Webbing, Straps, Buckles, And Fasteners.
(1)
(2)
(3)
(4)
Webbing, straps, and hook and pile fastenes are obtained from bulk stock. Cut each item from the correct
material (Section Ill) and to the same length as the item to be replaced.
Fuse the cut ends of webbing and straps before assembling for stitching. The method used to fuse the
webbing and strap ends shall provide sufficient heat to form a smooth uniform edge.
Using care not to damage attached fabric, cut away defective item by using a sharp edged tool or other
suitable device.
CAUTION
Do not stich through the KEVLAR ® ballistic filler except where stitched in the
original construction. Damage to the KEVLAR ® would result.
NOTE
If the ballistic filler falls under any retainer, it shall not be folded under or pushed
aside to avoid being caught in the stitching.
When it is necessary to open seams to remove defective webbings and other tabs, care should be
exercised to avoid damaging the KEVIAR ® ballistic filler. Opening of seams can be accomplished by using
a sharp-edged tool or other suitable device.
(5) Use matching stitching for stitching and restitching replacement items. Use Table 23-2 for the type of
stitches, thread size, and stitches per inch that are required for repair.
Change 4
23-13
