TM 10-8400-203-23
26-4 Change 10
(3) Front Pad
(3) Rear
Pad
(3) Side Pads
(1)
(2)
(4)
(5)
c. Impact Liner Assembly
ITEM (NSN)
SIZES
SPECIFICATION
Impact Liner Spider (8415-01-467-2216)
One Size
PDA3261199
Impact Liner Crown (8415-01-467-2189)
One Size
MIL-P-15280
Impact Liner Small (8415-01-467-2178)
Small
MIL-P-15280
Impact Liner Medium (8415-01-467-2181)
Medium
MIL-P-15280
Impact Liner Large (8415-01-467-2183)
Large
MIL-P-15280
The spider is constructed of a rigid one-piece, 3/8-inch thick, polyurethane foam. Two pieces of 3 ½ inch long
and 1 ½ inch wide pile fastener strips adhered to the crown of the liner provide adhesion when pressed against
the corresponding hook fastener tapes in the helmet shell. The inside of the liner is fitted with two, 1 ½ inch
wide and 3 ½ inch long, pieces of pile fastener strips along the crown and the sides. In addition, 1-inch wide
and 1½-inch long patches of pile fastener tape are attached to each of the fingers of the spider. The fitting pads
Consist of a crown, front, rear, and left and right side pads. They are cut from a smooth leather/vinyl material
on the outside, and both a flexible and semi-flexible foam urethane material on the inside. The pads are fitted
with 1-½ inch wide and 3 ½ inch long hook fastener strips that provide adhesion when pressed against the
correspondingly sized hook fastener pads on the liner.
(See Section III, Materials for Specific NSN’s and Part Numbers)
(1) Spider
(2) Crown Pad
(3) Front, Rear, and Side Impact Liner
(4) Hook Fastener Tape
(5) Pile Fastener Tape
Figure 26-3. Impact Liner Assembly
26-3. IDENTIFICATION AND DESCRIPTION - continued
