TM 10-3510-208-12
b. Cleaning.
Clean all parts- in a well-ventilated area.
Avoid inhalation of solvent fumes and
prolonged exposure of skin to cleaning
solvent. Wash exposed skin thoroughly.
Dry cleaning solvent (Fed. Spec. P-D-680)
used to clean parts is potentially dangerous
to personnel and property. Do not use near
open flame or excessive heat. Flash point
of solvent is 100 to 138F. (38 to 59C.).
Clean parts with cleaning solvent, Fed. Spec.
P-D-680, and dry thoroughly.
c. Inspection and Replacement.
(1) Inspect the conduit box and cover for
cracks or breaks.
(2) Inspect threaded parts for thread damage.
(3) Replace damaged or defective parts as
required.
d. Installation.
secure with screws (7).
(2) Install the connector (6) and connector
elbow (5).
(3) Install the conduits (4 and 3).
(4) Install the cover (2) and secure with
TS 3510-208-12/4-54
screws (1).
4-44. Tumbler Drive Motor and Related Parts
5. Bolt
1. Conduit
a. Removal.
4. Flatwasher
6. Flatwasher
2. Nut
(1) Tag and disconnect all wiring to the
7. Motor
3. Lockwasher
tumbler drive motor.
Figure 4-54. Tumbler drive motor and related parts,
(2) Tag and disconnect the two conduits (1,
removal and installation.
(3) Remove the nuts (2, fig. 4-54), lock-
washers (3), flatwashers (4 and 6) and bolts (5),
Clean all parts in a well-ventilated area.
securing the tumbler drive motor (7) to the dryer-
Avoid inhalation of solvent fumes and
tumbler.
4-70