Qualified civilian personnel (electrician) or military personnel in MOS 51R, 52C,
52D, or 52G are required to connect the 100 AMP power cables. Ensure all circuit
breakers in both circuit breaker panels are set to OFF to prevent shorting of
equipment when power is initially connected.
6. Connect 100 AMP, 50 ft cables (1) to power input plugs (2) and (3) on the power entry box (4).
7. Have qualified personnel, as noted above, connect pigtail connector end to 100 AMP, 50 ft cables (1) and then
connect the pigtails to the power source.
8. If TEMPER interior lights are used, lay out and connect 120VAC extension cord (5) (in footlocker) to the TEMPER
lights (6) and lay out towards the GFCI receptacle (7) on the power entry panel (4).
9. Switch main breakers in both power distribution panels to ON. Switch circuit breakers #1on the right side panel,
and circuit breaker #17 on left side panel (if needed) to ON. To operate the interior lights, turn the switch on the side
wall to ON.