DEPARTMENT OF THE ARMY TECHNICAL BULLETIN
VISUAL INSPECTION PROCEDURE
FOR SMALL ARM GAGES
Headquarters, Department of the Army, Washington, DC
10 March 2013
Distribution Statement A: Approved for public release; distribution is unlimited.
REPORTING OF ERRORS AND RECOMMENDING IMPROVEMENTS
You can improve this manual. If you find any mistakes or if you know of a way to improve these
procedures, please let us know. Mail your letter or DA Form 2028 (Recommended Changes to
Publications and Blank Forms) directly to: Commander, U.S. Army Aviation and Missile Command,
ATTN: AMSAM-MSS-LP, Redstone Arsenal, AL 35898-5000. A reply will be furnished to you.
You may also send in your comments electronically to our E-mail address:
2028@redstone.army.mil or by fax 256-842-6546/DSN 788-6546. For the World Wide Web use:
https://amcom2028.redstone.army.mil. Instructions for sending an electronic 2028 can be found at
the back of this manual.
Paragraph
Page
Purpose ...............................................................
Applicability .......................................................
Forms ..................................................................
General ...............................................................
1. Purpose. This technical bulletin (TB) describes the procedure for visually inspecting
and extending the interval for small arm gages.
NOTE
Model 5351217 is not covered by this procedure
2. Applicability. This TB is applicable to the scheduling calibration activity (scheduled
unit identification code or SUIC) for all users of small arms gages. The guidance included is
applicable to all schedulers to include DOD Civilians, Active Army, Army National Guard,
and US Army Reserves providing calibration scheduling service for small arm gages.
3. Forms, Records, and Reports. Forms, records, and reports required for calibration
personnel at all levels are prescribed by TB 750-25.
