01 March 2005
NAVAIR 01-1A-509-3
TM 1-1500-344-23-3
TO 1-1-689-3
d. (AF) After completion of drying step for all avionic
10-5.2.4. Hot Air Blower.
components, apply Water-Displacing Corrosion
Preventive Compound, Ultra-Thin Film, Avionics Grade,
WARNING
MIL-C-81309 Type III, or Water Displacing Lubricant
and Corrosion Preventive Compound, MIL-L-87177
Compressed air used for drying can create
Type I or II Grade B (Volume V, Chapter 2).
airborne particles that may enter the eyes.
Pressure shall not exceed 10 psi. Eye protection
10-5.2.3. Vented Drying Oven (Bulb Type).
is required.
a. Blow off excess liquid with not more than 10 psi
WARNING
dry air pressure or dry nitrogen. Deflect jet of air off
Compressed air used for drying can create
interior, back, and sides of enclosure to diffuse.
airborne particles that may enter the eyes.
Pressure shall not exceed 10 psi. Eye protection
b. Dry the equipment with a Hot Air Blower
is required.
(Volume IV or V, Chapter 3).
a. Blow off excess liquid with not more than 10 psi
dry air pressure or dry nitrogen. Deflect jet of air off
interior, back, and sides of enclosure to diffuse.
Compound, Corrosion Preventative 3
Water-Displacing
b. Place equipment in oven and dry the equipment
MIL-C-81309
at approximately 130F (54C) for 4 to 6 hours.
c. (N) (A) For all avionic components and electrical
connectors, apply by spraying Water-Displacing
Corrosion Preventive Compound, Ultra-Thin Film,
Compound, Corrosion Preventative 3
Avionics Grade, MIL-C-81309 Type III (Volume IV,
Water-Displacing
MIL-C-81309
d. (AF) For all avionic components and electrical
c. (N) (A) For all avionic components and electrical
connectors, apply by spraying Water-Displacing
connectors, apply by spraying Water-Displacing
Corrosion Preventive Compound, Ultra-Thin Film,
Corrosion Preventive Compound, Ultra-Thin Film,
Avionics Grade, MIL-C-81309 Type III, or Water
Avionics Grade, MIL-C-81309 Type III (Volume IV,
Displacing Lubricant and Corrosion Preventive
Compound, MIL-L-8717 Type I or II Grade B (Volume V,
d. (AF) For all avionic components and electrical
connectors, apply by spraying Water-Displacing
10-5.2.5. Heated Compartment.
Corrosion Preventive Compound, Ultra-Thin Film,
Avionics Grade, MIL-C-81309 Type III, or Water
WARNING
Displacing Lubricant and Corrosion Preventive
Compound, MIL-L-87177 Type I or II Grade B (Volume V,
Compressed air used for drying can create
airborne particles that may enter the eyes.
Pressure shall not exceed 10 psi. Eye protection
is required.
a. Blow off excess liquid with not more than 10 psi
dry air pressure or dry nitrogen. Deflect jet of air off
interior, back, and sides of enclosure to diffuse.
10-8
