NAVAIR 01-1A-509-4
01 September 2013
TM 1-1500-344-23-4
CHAPTER 1
INTRODUCTION
This volume was prepared under the technical cognizance of the
Materials Engineering Division, NAVAIR North Island, San Diego, California.
1-3. SCOPE. The material in this manual contains
1-1. GENERAL . Consumable materials and
basic corrosion prevention and corrective maintenance
equipment listed in this volume shall be used for corrosion
information to be used at Organizational, Intermediate,
control. Materials and equipment have been approved
and Depot levels.
only after extensive testing to prove their ability to
perform properly and effectively without damaging any
ARRANGEMENT OF MANUAL.
of the metallic or nonmetallic materials used in aircraft
or avionics. Only those materials listed in this manual
1-4-1. A complete set of manuals to perform aircraft
shall be used for cleaning or corrosion control. Materials
listed in other manuals shall be used only when required
cleaning and corrosion control functions consists of
Volumes I, II, and IV. A complete set of manuals to
procedures are not covered by this manual. When
perform avionics and electronics cleaning and corrosion
approved materials are not available, substitutions shall
control functions consists of Volumes I, III, and IV.
only be made by the appropriate Aircraft Controlling
Custodians (ACC) or System Program Manager (SPM).
1-4.2. Arrangement of Volume IV. Volume IV consists
of four chapters, arranged as shown in Table 1-1.
1-2. PURPOSE. The purpose of this manual is to
provide ordering information for consumable materials
RELATED PUBLICATIONS. None.
and equipment used to prevent, control, and repair
corrosion damage to aircraft and avionics.
Table 1-1. Outline of Volume IV
CHAPTER
TITLE
BRIEF DESCRIPTION
1
Introduction
This chapter presents the scope and layout of this volume.
2
Consumable Materials
This chapter provides information on the approved materials for cleaning,
for Corrosion Control
corrosion prevention, and corrosion control for aircraft and avionics.
3
Equipment for
This chapter provides information on approved equipment used for cleaning,
Corrosion Control
corrosion prevention, and corrosion control for aircraft and avionics.
4
Special Avionic
This chapter lists the requirements for special cleaning equipment used in an
avionic corrosion control work center.
Equipment
1-1/(1-2 Blank)
