TM 10-1670-300-20&P
TO 14D1-2-469-2
NAVAIR 13-1-42
CAUTION
Ensure that no adhesive is allowed to spread on the top
or bottom portion of the rubber seal.
(3) Holding serviceable seal (1) with toothpick or other small, sharp instrument (4) inserted in slit (5),
slowly rotate seal (1) in adhesive (6) until all of outer edge of seal (1) is lightly coated Next, tilt seal (1)
whereby it can be rotated again to apply a light coat of adhesive (3) on bottom outer edge of seal (1)
(4) Using toothpick or other instrument (4), carefully insert seal (1) into bush (2)
(5) Remove toothpick or other instrument (4) from slit (5) and use it to press seal (1) fully into the seat of
bush (2).
(6) Allow bush (2) and seal (1) to sit for two hours before install into FF-2 Release.
REPLACE
Replace an unserviceable FF-2 Release with a serviceable one from stock.
2-56
