TM 10-3510-208-12
(8) Place the dog (24) on shaft and secure
Clean items with cleaning solvent, Federal
with taper pin (23).
Specification P-D-680, and dry thoroughly.
(9) Slip support (22) on shaft.
c. Inspection and Repair.
(1) Inspect all parts for damage.
(10) Position a new gasket (21) on the housing
(2) Replace all damaged parts.
(20).
d. Installation.
(11) Secure the housing (20) with washers (19)
(1) Place the cylinder assembly (41, fig. 4-98)
and screws (18).
in the mounting bracket (40), slip the straight pin
(12) Install the support (17) and secure it with
(39) through bracket and cylinder.
screws (16), washers (15) and nuts (14).
(13) Install knob (13) on lever (11).
(2) Install mounting hardware for bracket and
cylinder assembly. Install washer (38), screw (37),
(14) Install nut (12) and lever (11). Tighten
nut (12).
nut (36) and setscrew (35).
(3) Install lever (33) on shaft (34): secure lever
(15) Install straight pin (10) and cotter pin
on shaft with taper pin (32).
(9).
(4) Install setscrew (31) .
(16) Install adapter (8).
(17) Install elbow (7).
(5) Install taper pin (29, fig. 4-98) securing
lever (30).
(18) Install nut (6) and assemble tubing (5)
and tube assembly (4).
(6) Position a new gasket (28) on cover (27).
(19) Install nut (3) and tubing (2); connect
(7) Secure the cover (37) on the housing with
tube assembly (1).
washers (26) and screws (25).
Section XXIV. WASHER-EXTRACTOR MOTORS,
DRIVE,
HYDROSHEAVE
AND RELATED PARTS
4-76. Washer Motor, Drive Belts and Sheave
(2) Refer to figure 4-100 for Edro Model and
remove the washer motor, drive belts and sheave.
a. Removal.
(1) Refer to figure 4-99 for Eidal Model and
remove the washer motor, drive belts and sheave.
4-140
