TM 10-3510-208-12
TS-10-3510-208-12/4-100
Figure 4-100. Washer motor, drive belts, and sheave, removal and installation (Edro Model EP120-LTU).
b. Cleaning.
c. Inspection and Repair.
(1) Inspect all parts for damage.
(2) Replace all damaged parts.
Clean all parts in a well-ventilated area.
Avoid inhalation of solvent fumes and
d. Installation.
prolonged exposure of skin to cleaning
(1) Refer to figure 4-100 for Edro Model and
solvent. Wash exposed skin thoroughly.
install the sheave, washer motor and drive belts.
Dry cleaning solvent (Fed. Spec. P-D-680)
(2) Refer to figure 4-99 for Eidal Model and
used to clean parts is potentially dangerous
install the sheave, washer motor and drive belts.
to personnel and property. Do not use near
e. Drive Belt Adjustment.
open flame or excessive heat. Flash point
(1) Refer to figure 4-101 (Eidal Model
of solvent is 100 to 138F. (38 to 59C.).
ELT9T, only) and adjust the drive belts.
(2) Refer to figure 4-102 (Edro Model
(1) Clean the outer surface of the motor and
EP120-LTU, only) and adjust the drive belts as
sheave using a cloth dampened in cleaning solvent,
follows: Loosen motor mounting nuts and adjust
Fed. Spec. P-D-680, and dry thoroughly.
belts to 1/2 inch (1.27 cm) deflection between
(2) Clean the drive belts using a dry clean
cloth.
4-142
