TM 10-3510-208-12
(3) Refer to figure 4-103 for Eidal Model and
install the extractor motor, drive belts and
sheave.
Clean all parts in a well-ventilated area.
e. Drive Belt Adjustment.
Avoid inhalation of solvent fumes and
(1) Refer to figure 4-107 and adjust the drive
prolonged exposure of akin to cleaning
solvent. Wash exposed skin thoroughly.
belts. (Eidal Model ELT9T only).
(2) Refer to figure 4-104 and the following
Dry cleaning solvent. (Fed. Spec.
instructions and adjust drive belts. (Edro Model
P-D-680) used to clean parts is potentially
EP120-LTU only). Loosen motor mounting nuts
dangerous to personnel and property. Do
and adjust belts to 1/2 inch (1.27 cm) deflection
not use near open flame or excessive heat.
between pulleys.
Flash point of solvent is 100 to 138F. (38
CAUTION
to 59C.).
To prevent excessive drive belt wear and
(1) Clean the outer surface of the motor and
breakage, it is essential that care be taken
sheave using a cloth dampened in cleaning solvent
to insure that a proper adjustment of the
Fed. Spec. P-D-680, and dry thoroughly.
time relay is obtained. The correct time
(2) Clean the drive belts using a dry clean
interval delay after completion of the
cloth.
extract cycle, complete braking, of the
c. Inspection and Repair.
cylinder, return of the washer motor to the
(1) Inspect all parts for damage.
was position, and the release of access door
(2) Replace all damaged parts.
air cylinder lock is forty seconds. Arrows
d. Installation.
shown on the relay body indicate the
(1) Refer to figure 4-106 and install the
direction of adjustment to increase or
hydro-sheave. (Edro Model EP120-LTU only).
decrease the time delay intervals.
(2) Refer to figure 4-104 for Edro Model and
install the extractor motor, drive belts and sheave.
4-148
