TM 10-3510-208-12
TS 3510-208-12/4-108
Figure 4-108. Jackshaft sheave, and belt guard removal and installation(Edro Model EP120-LTU.
(2) Replace all damaged parts.
d. Installation.
(1) Refer to figure 4-108 for Edro Model and
Clean all parts in a well-ventilated area.
install the jackshaft, sheave and belt guard.
Avoid inhalation of solvent fumes and
(2) Refer to figure 4-107 for Eidal Model and
prolonged exposure of skin to cleaning
solvent. Wash exposed skin thoroughly.
install the jackshaft, sheave and belt guard.
Dry cleaning solvent (Fed. Spec. P-D-680)
4-80. Washer Motor and Extractor Base
used to clean parts is potentially dangerous
G u i d e Rods, Air Piston, Micro-
to personnel and property. Do not use near
switch and Spring.
open flame or excessive heat. Flash point
CAUTION
of solvent is 100 to 138F. (38 to 59C. ).
A cumulation of dirt on the guide rod
Clean all parts using cleaning solvent, Federal
surface will create a binding action
Specification P-D-680, and dry thoroughly.
preventing travel of the washer motor base
c. Inspection and Repair.
into the extract position. The surface must
(1) Inspect all parts for damage.
be thoroughly cleaned and lubricated.
4-151
