TM 10-3510-209-10
1-13. EXTRACTOR.
The extractor uses centrifugal force to extract water from the wash load prior to the drying process. It is
powered by a 3-hp (2 238 W) motor. The extractor control has a 10-minute variable timer and has a load
capacity of 30 pounds (14 kg).
1-14. DRYER.
The heavy-duty dryer is powered by an externally-mounted 1/2 hp (373 W) motor and drive train. It has a
capacity of 30 pounds (14 kg) per load, approximately four loads per hour. Controls provide for an adjustable
range of 15 minutes for the drying cycle. Air is heated by a fuel-fired air heater mounted on the dryer.
1-15. WATER HEATER.
The water heater heats incoming water for the washer assembly.
1-16. WATER PUMP.
The portable, centrifugal-type water pump is mounted in a carrying frame. The pump is stored on the right front
side of the trailer during transport. During use, it is placed near the water source and connected to the facility
by a water output hose and power cable. After the initial prime, the pump will deliver 18 to 20 gallons (68 to 76
liters) of water per minute.
1-17. AIR COMPRESSOR.
The air compressor provides air pressure for the operation of washer water intake and drain valves. The
adjustable range of compressed air is 20 to 80 psi (138 to 552 kPa).
1-18. GENERATOR AND POWER DISTRIBUTION BOX .
The generator is mounted on the right-hand side of the trailer. Refer to TM 5-6115-585-12 for general
description. The laundry unit operates on 60-Hertz, 3-phase, 208 V ac power. An electrical panel provides
power distribution from the engine generator to the components of the laundry facility. The panel includes the
necessary circuit breakers for powering facility components.
1-10
