TM 10-3510-209-10
2-7. SITE SELECTION, SETUP, AND ASSEMBLY. (CONT)
(4)
Connect two 7-inch (178 mm) combustion exhaust ducts (5) together and connect to water
heater exhaust port (6). Extend duct full length away from rear of trailer. Do not touch or
cross other exhaust ducts, power cables, water hoses, or fuel lines.
(5)
Connect two 2-inch combustion exhaust ducts (7) to generator exhaust ports (8). Extend
ducts away from trailer assembly. Do not touch or cross other exhaust ducts, power cables,
water hoses, or fuel lines.
2-8. PREPARATION FOR USE.
a.
Generator. Ensure that the ON/OFF switch on the water pump and water heater are in the OFF
position and that all circuit breakers in the power distribution box are turned off.
FIGURE 2-16. Exhaust duct removal from trailer.
Change 1 2-48
