TM 10-3510-209-10
2-7. SITE SELECTION, SETUP, AND ASSEMBLY. (CONT)
e.
Remove and install dryer bin as follows:
(1)
Remove four bolts (1, FIG. 2-13) located inside dryer bin (2).
(2)
Remove dryer bin (2) and place it in front of dryer assembly (3).
(3)
Install bolts (1) removed in step (1) in the same locations from which they were removed.
f.
Make dryer fuel line connections as follows:
WARNING
Use only specified fuel (item 10, app C). Failure to do so may result in death or
serious injury to personnel or damage to equipment.
(1)
Obtain two fuel lines (1, FIG. 2-14).
WARNING
Ensure that fuel lines (1, FIG. 2-14) do not touch or cross water hoses, power
cables, or exhaust ducts. Melting/damage can occur causing leaking fuel and
water or electrical hazards. Death by electrocution, fire, or explosion could result.
(2)
Connect one fuel line (1) to fuel filter inlet (2) and one fuel line to fuel pump outlet (3).
(3)
Connect the other ends of fuel lines (1) to drum fill adapter (4). The line from the fuel filter
connects to fitting labeled SUPPLY on drum fill adapter. The line from the bottom of fuel
pump connects to fitting labeled RETURN on the drum fill adapter.
NOTE
The drum fill adapter can be used with 55-gallon (208 liter) drums (5), 5-gallon (19
liter) cans (6), or other fuel sources.
(4)
If a 55-gallon (208 liter) drum (5) is being used as the fuel source, remove drum fill adapter
extension (7) from the bottom of the return port and install it in the drum fill adapter pipe.
When using 5-gallon (19 liter) cans (6), the extension remains attached to the return port.
Change 1 2-43
