TM 55-1945-205-24-4
2-38. WATER HEATER FUEL FILTER ASSEMBLY (CONT)
REPAIR (Cont)
WARNING
Drycleaning solvent P-D-680 is toxic
and flammable. Wear protective
goggles and gloves and use only in a
well-ventilated area. Avoid contact
with skin, eyes, and clothes and don't
breathe vapors. Do not use near
open flame or excessive heat. The
flash point is 100-138° F (38-59° C). If
you
become
dizzy
while
using
cleaning
solvent,
get
fresh
air
immediately and get medical aid. If
contact with eyes is made, wash your
eyes with water and get medical aid
immediately.
4.
Clean all parts in dry-cleaning solvent.
5.
Install two preformed packings (21), nipple (20),
and handle (19) on fuel filter (7).
6.
Install gasket (18), filter bowl (17), and securing
plate (16) and secure to fuel filter (7) with four screws
(15).
7.
Install brace (14) on fuel filter (7) and secure
with two screws (13), lockwashers (12), and nuts (11).
INSTALLATION
1.
Install large nipple (10) on filter (7) inlet side and
small nipple (9) in fuel filter outlet side.
2.
Position fuel filter (7) on water heater brace
(14A) and secure with two screws (5), flat washers (6),
lockwashers (4), and nuts (3).
3.
Connect hose (2) to large nipple (10).
4.
Connect hose (1) to small nipple (9).
NOTE
If bowl and gasket were replaced,
ensure there are no fuel leaks.
NOTE
FOLLOW-ON MAINTENANCE:
Install tarp assembly (TM 9-3510-209-10).
Change 1 2-137
