TM 10-3510-209-24
Table 3-1. Intermediate Direct Support Troubleshooting (Continued)
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
3.
WASHER CYLINDER WILL NOT ROTATE (AUTOMATIC MODE). (Cont)
Step 2.
Check for improper adjustment of tension of contact fingers.
a.
Adjust for proper tension of contact fingers. (Refer to paragraph 3-11.)
b.
If problem persists, go to next step.
Step 3.
Check for broken drivebelt.
a.
Replace drivebelt. Refer to paragraph 3-10.
b.
If problem persists, proceed to next step.
Step 4.
Check for defective drive motor. Check for rough, noisy, or overheating condition.
a.
Replace drive motor. Refer to paragraph 3-13.
b.
If problem persists, proceed to next step.
Step 5.
Check for defective gear reduction unit. Check for rough or high-friction turning of shafts.
a.
Repair or replace gear reduction unit. Refer problem to Intermediate Direct Support Maintenance.
b.
Proceed to next step.
Step 6.
Check for internal failure of controller assembly.
a.
Refer controller assembly problem to Intermediate Direct Support Maintenance.
b.
If problem persists, notify your supervisor.
4.
WASHER CYLINDER ROTATES ONLY IN ONE DIRECTION.
Check for defective reversing switch inside controller assembly.
a.
Replace reversing switch. (Refer to paragraph 3-11.)
b.
If problem persists, notify your supervisor.
3-4 Change 2
