TM 10-3510-209-24
Table 3-1. Intermediate Direct Support Troubleshooting
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
WASHER ASSEMBLY
1.
WASHER WILL NOT OPERATE.
Step 1.
Check for broken wiring. Use a multimeter and test wiring for continuity.
a.
If wire is broken, replace defective wire. (Refer to paragraph 3-7.)
b.
If wire is not damaged, proceed to next step.
Step 2.
Check for cracked, worn, or broken motor parts, damaged shaft, threads, and bent shaft.
a.
If motor is damaged, repair or replace drive motor. (Refer to paragraph 3-13.)
b. If motor is not damaged, proceed to next step.
Step 3.
Check for motor overload.
If motor overloads, repair or replace bearing as required. (Refer to paragraph 3-13.)
2.
WASHER WILL NOT FILL WITH COLD/HOT WATER (AUTOMATIC MODE).
Check for dirty contact fingers between controller drum and hot water control finger No. 15 or cold water finger
No. 16.
a.
Clean contact finger and drum screen. (Refer to paragraph 3-11.)
b.
If problem persists, notify your supervisor.
3.
WASHER CYLINDER WILL NOT ROTATE (AUTOMATIC MODE).
Step 1.
Check for dirty contact fingers and/or dirty drum.
a.
Clean contact fingers and drum screen. (Refer to paragraph 3-11.)
b.
If problem persists, proceed to next step.
3-3
