TM 10-3510-209-24
3-20. WATER HEATER ELECTRIC CONTROL ASSEMBLY (CONT)
TEST (Cont)
NOTE
It may be necessary to remove receptacle (4) from circuit box (3) to contact rear
output pins.
5.
Use multimeter on low ohms scale and check continuity from the front of receptacle (4) to rear output on each pin.
Replace receptacle (DISASSEMBLY, step 1, and ASSEMBLY, step 11) if continuity is not indicated on any pin.
6.
Remove cover (5) on power limit switch (1) and inspect overload heaters for damage. Replace overload heaters
(DISASSEMBLY, step 3, and ASSEMBLY, step 9) if defective.
3-89
