TM 10-3510-209-24
3-29. WATER PUMP (CONT)
ASSEMBLY (Cont)
NOTE
Ensure that the proper shims (13) are
used to provide approximately 0.004
inch (0.1 mm) clearance between
impeller (12) and vane plate (8) when
water pump is fully assembled.
9.
Install spring (16), spring cup (15), seal
washer (14), impeller shims (13), and
impeller (12) on motor shaft (11).
10.
Install impeller jam nut (10) on motor shaft
(11). Place screwdriver in slot (9) and
hold motor from turning.
11.
Install vane plate (8) and two machine
screws (7).
12.
Install O-ring (5) and gasket (4) on
housing (3).
13.
Install housing (3) and six hex nuts (1) on
studs (2).
NOTE
FOLLOW-ON MAINTENANCE:
Install water pump on trailer
(TM 10-3510-209-10).
3-140
