TM 10-3510-220-24
3-10. WASHER ASSEMBLY (CONT)
REMOVAL (Cont)
2 .
The level switch tube and all conduits except incoming power are part of the control console;
disconnect them from the locations to which they are connected; motor at top junction box and
door lock at cover, disconnect level switch tube at air trap. Incoming power wires are
disconnected inside console at terminal strip and conduit disconnected from rear of control
console.
3.
Remove drivebelt cover (1) by turning the four quarter-turn wing head studs (5) counter-
clockwise and pulling out on studs, then slide drivebelt cover to rear to remove.
3-16
