TM 10-3510-220-24
3-10. WASHER ASSEMBLY (CONT)
DISASSEMBLY (Cont)
d.
Remove two setscrews (46) and remove
two set collars (45) from basket shaft
(49) where it passes through the gear reducer
(36) (one on front, one on back).
e.
Loosen the three set screws (48) in the quill (47)
of the gear reducer (36) on both sides.
f.
Slide washer cylinder (35) forward until clear
of gear reducer and seal assembly
(located on rear of washer drum).
3.
Remove gear reducer.
WARNING
Components of the washer assembly are
heavy and may be awkward to handle. Use
correct lifting procedures, lifting devices,
and/or assistance from other personnel to
avoid injury.
a.
Remove three bolts (42), lock-
washers (43), and insert in jacking
holes tighten bolts to remove
sheave and bushing assembly (44),
remove key (37) from gear reducer
(36).
NOTE
Use shims as required.
b.
Support gear reducer (36) and
remove four bolts (38), lockwashers
(39), flatwashers (40) attaching gear
reducer mounting plate to “Z” bars
and remove gear reducer (36) with
mounting plate attached.
3-20
