TM 10-3510-220-24
3-11. WASHER CONTROLLER ASSEMBLY (CONT)
REMOVAL
WARNING
1.
2.
3.
4.
High voltage is present on this equipment. Do not perform maintenance
with power on. Death or serious injury may result.
Remove twelve screws (1) and remove top panel (2) from controller (3).
NOTE
A record of wire removal is needed so that installation hookup is exactly
duplicated. Refer to Figure 2, Appendix E.
Locate wires coming from door lock, motor, and incoming power conduits on inside of controller
(3). Tag and disconnect each wire individually.
Cut nylon ties as needed.
Remove three locknuts (4) from conduit fittings on inside of controller (3). Remove conduit,
fittings, and wires from controller.
Tag and remove hoses (5).
Disconnect level tube at air trap.
Remove four locknuts (8), eight washers (7), from controller (3) and stand (6).
Remove controller (3) from stand (6).
5.
6.
7.
8.
INSTALLATION
1.
2.
3.
4.
5.
6.
7.
WARNING
High voltage is present on this equipment. Do not perform maintenance
with power on. Death or serious injury may result.
Position controller (3) on stand (6). Install eight washers (7), and four locknuts (8).
Install wires and fittings of four conduits through holes of controller (3). Install three locknuts
(4) on conduit fittings.
Connect each wire to its proper connector and remove tags. Tie wire bundles with wire ties
(Item 11, App C) as needed.
Install hoses (5) and remove tags.
Connect level tube at air trap.
Position top panel (2) on controller (3) and install twelve screws (1).
Perform follow-on installation.
Install tarp assembly (TM 10-3510-220-10).
3-38
