TM 10--3510--221--10 0024 00--17/18 blank LAUNDRY ADVANCED SYSTEM PREVENTIVE MAINTENANCE CHECKS AND SERVICES -- Continued 0024 00 TABLE 1. Operator PMCS -- Continued. ITEM NO. INTERVAL MAN-- HOUR ITEM TO BE CHECKED OR SERVICED PROCEDURE EQUIPMENT NOT READY/ AVAILABLE IF: NOTE Perform Weekly, Monthly, Quarterly, and Semi--Annual checks as part of After PMCS. 43 Weekly Water tanks Drain and refill water tanks (WP 0009 00 and WP 0012 00). Water tanks are not filled with fresh water. 44 Monthly Dryer heat exchangers Inspect heat exchangers (1) for debris blocking fins, also check for bent fins. Clean or straighten fins as necessary. Fins are blocked with debris or are bent. 45 Monthly Washing/Drying drums Lubricate drum bearings (WP 0041 00). Not lubricated Lubricate rear drum seals (WP 0041 00). 46 Monthly Still condenser Inspect heat exchangers (2) for debris blocking fins, also check for bent fins. Clean or straighten fins as necessary. Fins are blocked with debris or are bent. 47 Monthly Subcooler Inspect subcooler (3) for debris blocking fins, also check for bent fins. Clean or straighten fins as necessary. Fins are blocked with debris or are bent. 48 Monthly Evaporative cooler demister mesh Clean/Inspect demister mesh (WP 0034 00). Demister mesh is damaged or not clean 49 Monthly Air system inlet filter Replace inlet filter (WP 0037 00). Filter element is not clean 50 Monthly Air system Replace coalescing filter element (WP 0038 00). Element is clogged. 51 Quarterly Washing/Drying drums Lubricate drive motors (WP 0041 00). Not lubricated 52 Quarterly Heater Lubricate thermal fluid pump motor (WP 0041 00). Not lubricated 53 Quarterly Load binders Lubricate drum stowage load binders (WP 0041 00). Not lubricated 54 Semi-- Annually Protective tarp Inspect for: a. Tears in material (4). b. Fraying on edges of material (4). c. Security of straps (5). d. Missing or damaged buckles (6). Tarp is damaged