TM 10--3510--221--10 0024 00--13 LAUNDRY ADVANCED SYSTEM PREVENTIVE MAINTENANCE CHECKS AND SERVICES -- Continued 0024 00 TABLE 1. Operator PMCS -- Continued. ITEM NO. INTERVAL MAN-- HOUR ITEM TO BE CHECKED OR SERVICED PROCEDURE EQUIPMENT NOT READY/ AVAILABLE IF: 23 During Inverter enclosure fan Ensure fan (1) is blowing air out of enclosure after start--up. Filters are damaged or not clean 24 During Drum motor cooling fans Ensure fans (2) are blowing air around drive motors after start--up. Filters are damaged or not clean 25 During Air system coalescing filter When air compressor (3) is on, ensure indicator (4) on coalescing filter (5) is green. Indicator is red 26 During Water coalescing filter bleed valve During heat tanks operation, ensure water is dripping from drain tube (6) at 20 to 40 drops per minute. Adjust drain valve (7) as necessary to obtain proper drain rate. Water is not dripping out of drain tube 27 During Dryer lint filters Clean/Inspect lint filters (WP 0027 00) after each laundry cycle. Filters are damaged or not clean 28 During Water pump strainer Clean strainers (WP 0029 00) after every fifth laundry cycle. Strainers are damaged or not clean 29* During Fuel supply Check for adequate supply of fuel (JP--8) in external container (8). Fuel supply is < 200 gals 30* During Water supply Check for adequate supply of water in external container (9). Water supply is < 300 gals 31* During Water plumbing Check water plumbing (10) for evidence of leakage. Any class III leak is detected 32* During Thermal fluid plumbing Check thermal fluid plumbing (11) for evidence of leakage. Any class II leak is detected 33* During Anti--foam supply Check for adequate supply of anti--foam in external containers (12) and (13). Anti--foam supply is < 1 gal 34* During Detergent supply Check for adequate supply of detergent in external container (14). Detergent supply is < 1 gal NOTE -- Items marked * should be checked at shift change by the on coming shift.