TM 10--3510--221--24
0123 00--2
DOOR ASSEMBLY REPLACEMENT -- Continued
0123 00
INSTALLATION
1. Install new door (2) onto rod ends (11), then secure with two screws (8), lock washers (9), and flat
washers (10).
CAUTION
When checking door alignment, forcing door to close or handle to latch, may result on
damage to either component.
2. Verify correct alignment of door (2) as follows:
a. Swing door (2) back and forth. Door movement should be free with no binding.
b. Close door (2) and engage handle (1). Handle should engage without excessive force.
c. With door (2) closed and handle (1) engaged verify door gasket (12) is contacting ring (13) around entire
circumference.
d. Pull out on handle (1) and open door (2). Handle should disengage without excessive force.
3. If door (2) is properly aligned proceed to step 4, otherwise realign door as follows:
a. Remove two screws (8), lock washers (9), and flat washers (10), then remove door (2) from rod ends (11).
b. Loosen two jam nuts (14).
c. Thread rod ends (11) in or out as necessary to correct door alignment.
d. Install door (2) onto rod ends (11), then secure with two screws (8), lock washers (9), and flat washers (10).
e. Tighten two jam nuts (14).
f. Repeat step 2 to check alignment of door (2).
4. Locate actuator (6) on mounting bracket (7), then secure with two screws (3), lock washers (4), and flat
washers (5).
5. Check alignment and adjustment between actuator (6) and position switch (15) (WP 0128 00).
6. Perform a test laundry cycle (TM 10--3510--221--10). Visually check for water leaks around door (2) while
laundry cycle is underway.
END OF WORK PACKAGE
