TM 10--3510--221--24
0168 00--1
RINSE 2 TANK INLET TEMPERATURE SENSOR
REPLACEMENT
0168 00
THIS WORK PACKAGE COVERS:
Removal, Installation
INITIAL SETUP:
Maintenance Level
Materials/Parts
Unit
Sealant, Pipe Thread (Item 6, WP 0271 00)
Tools and Special Tools
Equipment Conditions
Tool Kit, General Mechanics (Item 1, WP 0272 00)
LADS power shut off at main control
enclosure (WP 0112 00).
REMOVAL
WARNING
Distillate piping can reach temperatures near 200o F when the water recycle system is
operating. Allow piping to cool prior to performing maintenance. Always wear gloves and
eye protection. Failure to follow this precaution could result in severe burn injuries.
1. Disengage two latches (1), then open access door (2).
1. Disconnect electrical connector (3) from temperature sensor (4).
2. Loosen nut (5) then remove temperature sensor (4) from fitting (6).
3. Measure and record distance from tip of temperature sensor (4) to lower ferrule (7).
4. Unthread fitting (6) from piping (8).
5. Clean pipe thread sealant from threads of fitting (6).
