TM 10--3510--221--24
0263 00--3/4 blank
STILL CONDENSER FAN MOTOR REPLACEMENT --
Continued
0263 00
INSTALLATION
1. Attach lifting device to three lifting points (10) on new motor (5). Raise motor to rear cover (19).
2. Remove four screws (18) then remove rear cover (19) from motor (5).
3. Install cooling air duct (17) onto rear cover (19), then secure both to motor with four screws (18).
4. Slide flexible duct (2) onto cooling air duct (17), then secure with clamp (16).
5. Lift motor (5) and position in fan shroud (10) high enough to access junction box (11).
6. Remove screw (12) then remove cover (13) from junction box (11).
7. Insert conduit (15) into junction box (11), then secure with conduit nut (14).
8. Connect wires at junction box (11) as tagged.
9. Install cover (13) onto junction box (11), then secure with screw (18).
10. Lower motor (5) into fan shroud (10), then align mounting holes.
11. Secure motor (5) to fan shroud (10) with four screws (6), flat washers (7), lock washers (8), and nuts (9).
12. Remove lifting device from motor (5).
13. Slide flexible duct (2) onto fan shroud (3), then secure with clamp (1).
14. Install fan blade (WP 0160 00).
END OF WORK PACKAGE
