TM 10-3510-222-10
CHAPTER 2
OPERATING INSTRUCTIONS
PARAGRAPH
TITLE
PAGE
Section I.
Description and Use of Operator's Controls and Indicators .......................................
2-1
2-1.
Introduction ......................................................................................................................
2-1
2-2.
Location and Use of Controls and Indicators ....................................................................
2-1
Section II.
Preventive Maintenance Checks and Services (PMCS) ............................................... 2-12
2-3.
Introduction.......................................................................................................................
2-12
2-4.
General Maintenance Procedures ....................................................................................
2-13
2-5.
PMCS Table ....................................................................................................................
2-14
Section III.
Operation Under Usual Conditions .............................................................................. 2-34
2-6.
Scope ..............................................................................................................................
2-34
2-7.
Assembly and Preparation for Use ...................................................................................
2-34
2-8.
Initial Adjustments and Checks ........................................................................................
2-57
2-9.
Operating Procedures ......................................................................................................
2-63
2-10.
Decals and Instruction Plates ...........................................................................................
2-75
2-11.
Preparation For Movement ..............................................................................................
2-80
Section IV.
Operation Under Unusual Conditions .......................................................................... 2-87
2-12.
Operation in Cold .............................................................................................................
2-87
2-13.
Operation in Dust or Sand ...............................................................................................
2-89
2-14.
Operation in Snow or Mud ...............................................................................................
2-89
2-15.
Operation in Saltwater Areas ............................................................................................
2-89
2-16.
Emergency Procedures ...................................................................................................
2-89
Section I.
DESCRIPTION AND USE OF OPERATOR'S CONTROLS AND INDICATORS
2-1.
INTRODUCTION.
This section shows the location and describes the use of controls and indicators you will use in operating your equipment.
2-2.
LOCATION AND USE OF CONTROLS AND INDICATORS.
a.
Trailer.
Refer to TM 9-2330-376-14&P for controls and indicators.
2-1
