TM 10-3510-222-10
2-2.
LOCATION AND USE OF CONTROLS AND INDICATORS - continued.
Key
Control or Indicator
Function/Use
1
Temperature Gage
Indicates temperature of water coming from water heater.
2
MANUALTIMER
Controls time (60 minutes) of operation during manual operation.
3
ON Indicator Light
Indicates machine is on.
4
SUPPLIES Indicator Light
In auto mode, indicates to operator that supplies are required.
5
TIMER Indicator Light
In manual mode, indicates time-out or supplies are needed.
6
DIMMER Switch
Provides control of brightness for ON/SUPPLIES/TIMER Indicator Lights.
7
MASTER ON/OFF Switch
Turns controller on/off.
8
AUTO/MANUAL /OFF Switch
Selects auto or manual operation, off position enables door unlock switch.
9
LEVEL LOW/1 Switch
Sets low level of water for automatic wash cycle or sets water level for manual when
LEVEL, SELECT is switched to 1.
10
LEVEL HIIGH/2 Switch
Sets high level of water for automatic wash cycle or
sets water level for manual when
LEVEL SELECT
is switched to 2.
11
DRAIN OPEN/CLOSED Switch Opens and closes drain valve.
12
LEVEL SELECT 1 or 2 Switch
Enables LEVEL LOW/1 switch or HIGH/2 switch to operate.
13
COLD WATER ON/OFF Switch Turns cold water valve on/off.
14
HOT WATER ON/OFF Switch
Turns hot water valve on/off.
15
Audible SIGNAL
Alerts operator that washer controls require attention.
16
SIGNAL CANCEL Switch
Cancels audible signal indicator.
17
RUN/STOP/Motor Switch
Engages/disengages auto mode drive and starts cycle timer.
18
Cylinder Control Wheel
Manually advances cylinder.
19
Door Unlock Switch
Unlocks washer door.
20
Soap Dispenser
Allows operator access to add supplies during the washing cycle
.
Figure 2-1. Washer Controls and Indicators (Sheet 2)
2-4
