TM 10-3510-222-10
2-7. ASSEMBLY AND PREPARATION FOR USE - continued.
e.
Water Pump - continued.
WARNING
Ensure that water hoses do not touch or cross other water hoses, exhaust ducts, power cables,
or fuel lines. Melting/damage can occur causing leaking fuel and water or electrical hazards.
Death by electrocution, fire, or explosion could result.
(4)
Connect suction strainer (11) to the other end of nonmetallic hose (10). Position the suction strainer (11) in
the water source above the stream bed. Make a tripod from tree branches or saplings and hang the strainer from the
place where the branches are tied together, or position the strainer on a bed of stones or gravel.
(5)
Connect nonmetallic hose (7) to water pump quick coupling half(8).
(6)
Connect the other end of the nonmetallic hose (7) to water heater quick coupling half (6).
(7)
Make sure water pump toggle switch (16) is OFF.
(8)
Make sure water heater electrical receptacle connector switch is OFF. (Reference TM 10-4520-259-13&P)
WARNING
Be sure that water pump cable does not touch or cross other water hoses, exhaust ducts, or fuel
lines. Melting/damage can occur causing leaking fuel and water or electrical hazards. Death by
electrocution, fire, or explosion could result.
(9)
Connect water pump distribution power cable (15) between water heater electrical receptacle connector
(13) and water pump electrical receptacle connector (14).
(10)
Install nonmetallic hose (4) to washer quick coupling half(12) and to water heater quick coupling half(5).
f
Nonmetallic HoseDrains. See Figure 2-14.
(1)
Be sure that nonmetallic hose (4) is connected to extractor quick coupling half (5) an d washer quick
coupling half (3).
WARNING
Be sure that drain hoses do not touch or cross other water hoses, power cables, exhaust ducts,
or fuel lines. Melting/damage can occur causing leaking fuel and water or electrical hazards.
Death by electrocution, fire, or explosion could result.
(2)
Connect one 25-foot (7.6 m), 1-1/2-inch-diameter nonmetallic hose (7) to wet wash bin quick coupling
half(6) and route the nonmetallic hose to a drain field.
2-44
