TM 10-3510-222-10
2-7. ASSEMBLY AND PREPARATION FOR USE - continued.
i.
Dryer Bin. See figure 2-17.
(1)
Remove four hexagon head cap screws (1), lock washers (2), and washers (3) located inside dryer bin (4).
Place hardware in toolbox.
(2)
Remove dryer bin (4) and place in front of dryer (5).
j.
Dryer Nonmetallic Hose Fuel Lines. See figure 2-18.
WARNING
Use diesel or JP-8 fuel only. Failure to do so may result in death or serious injury to personnel
or damage to equipment.
(1)
Do one of the steps below:
(a)
If using a 55-gallon (208 liters) drum, follow substeps below.
1.
Remove drum extension (4) from return outlet (8).
2.
Install drum extension (4) on pipe coupling (7).
3.
Install drum fill adapter (6) in drum (5).
(b)
If using a 5-gallon (19 liter) military gas can, install drum fill adapter (6) in military gas can.
WARNING
Be sure that nonmetallic hose fuel lines do not touch or cross water hoses, power cables, or
exhaust ducts. Melting/damage can occur causing leaking fuel and water or electrical hazards.
Death by electrocution fire, or explosion could result.
(2)
Locate nonmetallic hose fuel line (3) under dryer.
(3)
Connect one nonmetallic hose fuel line (3) to dryer fuel filter brass male connector (2) and one nonmetallic
hose fuel line (3) to dryer fuel pump 90° crescent fitting (1).
(4)
Position nonmetallic hose fuel lines (3) in clamp on right side of dryer and tighten clamp.
(5)
Connect the other ends of nonmetallic hose fuel lines (3) to drum fill adapter (6). The line from the fuel
filter connects to fitting labeled SUPPLY on drum fill adapter. The line from the bottom of fuel pump
connects to fitting labeled RETURN on the drum fill adapter.
2-50
