TM 10-3510-222-24
2-42. MOTOR ASSEMBLY - continued.
b.
INSTALLATION
(1)
Position key (19) on shaft of motor (8).
(2)
Install hub (18) on shaft of motor (8) as marked at disassembly and secure with setscrew (17).
(3)
Install pulley (16) on hub (18) and secure with three screws (14) and lockwashers (15).
(4)
Position motor (8) on motor mounting plate (23) and secure with four lockwashers (7) and bolts (6).
NOTE
When tension bolt and spring are engaged in groove of motor
mounting plate, belt tension is maintained by tension of spring
between motor mounting bolt and motor mounting plate.
(5)
Engage belt tension bolt (20) in groove of motor mounting plate (23).
(6)
Position belt (5) on pulley (16) and pulley of extractor drive (24).
(7)
Install gasket (12) and box connector (13) on conduit box (22) with nut (11).
NOTE
Wire numbers are stamped on each electrical wire. This
information, in conjunction with data on FO-3 Extractor Wiring
Diagram, may be used to connect wires if tags are lost or illegible.
(8)
Connect wires as tagged.
(9)
Position cover (10) on conduit box (22) and secure with two caps (9).
(10)
Position belt guard (3) and belt cover (4) over belt (5) and secure with lockwashers (2) and bolt (1).
2-104
