TM 10-3510-222-24
2-45. CLAMP.
This task covers:
a. Removal
b. Repair
c. Installation
INITIAL SETUP
Tools
General Mechanics Tool Kit (App B, Item 1)
NOTE
Both clamps are identical, only one is shown.
a.
REMOVAL
(1)
Upper clamp (supporting pipe) (3 and 5).
(a)
Remove two nuts (1), lockwashers (2), clamp (3) from rods (4).
(b)
Remove piping (13) (Para 2-46).
(c)
Remove clamp (5) and two lockwashers (6).
(2)
Lower clamp (attaching to guard) (9 and 10).
(a)
Remove four nuts (7) and two lockwashers (8).
(b)
Remove clamp (9), two rods (4), clamp (10), lockwashers (11) and two nuts (12).
b.
REPAIR
Repair consists of replacing damaged or missing components of the clamp.
c.
INSTALLATION
(1)
Upper clamp (supporting piping) (3 and 5).
(a)
Install two lockwashers (6) and clamp (5) on rods (4).
(b)
Install piping (13) (Para 2-46).
(c)
Install clamp (3), two lockwashers (2) and nuts (1).
(2)
Lower clamp (attaching to guard) (9 and 10).
(a)
Install two nuts (12), lockwashers (11), clamp (10), two rods (4) and clamp (9) at same position
as removed.
(b)
Install two lockwashers (8) and four nuts (7).
2-109
