TM 10-3510-222-24
2-65. DOOR SWITCH - continued.
b.
INSTALLATION
(1)
Position switch (11) on bracket (8) and install three screws (10) and nuts (9).
(2)
Position bracket (8) on dryer and install three lockwashers (7) and screws (6) finger tight.
(3)
Install adapter (5).
(4)
Feed wires (12) through conduit (17), connect nut (4) and gasket (18) to adapter (5).
NOTE
Wire numbers are stamped on each electrical wire. This
information, in conjunction with data on FO-4 Dryer Wiring
Diagram, may be used to connect wires if tags are lost or illegible.
(5)
Connect wires, as tagged.
(6)
Install cover (3) with four lockwashers (2) and screws (1).
(7)
Adjust switch for proper operation in accordance with adjustment procedure below.
c.
ADJUSTMENT
(1)
Open dryer door and check for proper operation of switch. Switch and cam operate properly if you can
hear a click when door is opened and closed.
(2)
If switch operates correctly, no adjustment is required. If not, proceed with step (3).
(3)
Loosen setscrew (13) and turn cam (14), or raise and lower it, so that screw (16) is centered on plunger
(15) when door is fully open.
(4)
Tighten setscrew (13).
(5)
If screw (16) is fully centered on plunger (15), but plunger is not fully depressed or door cannot be fully
opened because plunger (15) is too close to screw (16), turn screw (16) in or out for correct plunger (15)
travel.
2-153
