TM 10-3510-222-24
3-42. HINGE SHAFT ASSEMBLY.
This task covers:
a. Removal
b. Repair
c. Installation
INITIAL SETUP
Tools
General Mechanics Tool Kit (App B, Item 1)
Automobile Vehicle Shop Equipment
(App B, Item 3)
Materials/Parts
Grease (App D, Item 16)
Adhesive (App D, Item 23)
Equipment Condition
Laundry Unit shut down (TM 10-3510-222-10)
Lid Closed Switch removed (Para 3-49)
Lid Locked Switch removed (Para 3-50)
a. REMOVAL
(1) Remove twelve bolts (1), lockwashers (2), seal washers (3) and cover (4). As required, remove gasket (5).
(2) Remove two nuts (6) and bolts (7).
(3) Loosen setscrews (8 and 9).
(4) Move cam (15) on shaft (11) and remove key (10).
(5) Loosen brake adjustment screw (19).
(6) Remove shaft (11), two washers (12), frame (13) and cams (14 and 15).
(7) Remove screw (16), lockwasher (17) and brake (18). As required, remove grease fitting (27) and adjustment screw
(19) from brake (18).
(8) Remove two bushings (20).
(9) If required, remove two nuts (21), lockwashers (22), screws (23), bracket (24), screws (25) and bumper (26).
b. REPAIR
Repair consists of replacing damaged and/or missing components of the hinge shaft assembly.
c. INSTALLATION
(1) If removed, install bumper (26) on bracket (24) with two screws (25) and install bracket with two screws (23),
lockwashers (22) and nuts (21).
(2) Install two bushings (20).
(3) Install shaft (11), two washers (12), frame (13), key (10), cam (15), brake (18), screw (16), lockwasher (17) and
cam (14).
(4) Close lid (28).
(5) With lid closed, turn cam (14) until stud on cam is level and points to the rear of the extractor.
(6) Tighten setscrews (8 and 9).
(7) Install two bolts (7) and nuts (6), securing frame (13) to shaft (11).
(8) If removed, install grease fitting (27) and adjustment screw (19) and lubricate brake (18) (LO 10-3510-222-12).
3-97
