TM 10-3510-223-13&P
0037 00
0037 00-3
Install
NOTE
Prior to installation of a new pump, its power cord must be modified as
described in work package 0074, Figure 2.
WARNING
The water pump is heavy. To avoid injuries, two persons are required to
lift the wastewater pump.
Before proceeding with the installation of a new pump, drain the wastewater tank completely by removing
and reinstalling the drain plug when the tank is empty.
Install 2” PVC wastewater evacuation line section (1) onto new pump at union (2). Ensure pipe is oriented
correctly to connect to the union on top of the wastewater tank (3).
Place new, modified wastewater pump (4) into the foot wells (5) on the bottom of the wastewater tank.
Remove retainer pin from pump handle (6) and remove handle.
Place support bracket (7) into position and install two hex bolts (8).
Reinstall the handle (6) onto the pump. Place the power cord into cable clips (9) and install clips onto tank
wall. Feed wastewater pump power cord (10) through hole in tank cover (11). Feed the three float switch
power cords (12) separately through hole in wastewater tank cover (11).
Place the wastewater tank lid (13) into position and tighten captive screws (14) to secure the lid. Re-
connect the power cables of the wastewater pump (10) and the three float switches (12) to the
appropriately labeled receptacles on the curbside wall raceway. Install new cable ties (15).
Set main breaker in power distribution panel #1 to ON. Push PUMP RUN button on wastewater pump
control panel.
