TM 10-3510-226-23
UNIT MAINTENANCE
CONTAINERIZED BATCH LAUNDRY
NSN 3510-01-527-2209
NSN 3510-01-527-2210
SHOCK ABSORBERS
SPRINGS
INSPECT, REPLACE
INITIAL SETUP
Tools
Personnel Required
Shop Equipment, Automotive Maintenance and
Quartermaster and Chemical Equipment
Repair: Organizational Maintenance, Common No.1
Repairer 63J (2)
Materials/Parts
Equipment Condition
Cleaner, Lubricant, and Preservative (WP 0087,
CBL set up
Item 10)
References
TM 10-3510-226-10
INSPECT
Inspect the Washer Shock Absorbers
WARNING
Ensure that all electrical power is shut off and disconnected before proceeding. The
Circuit Breaker box should be locked by personnel following this procedure. Serious
injury or death can result from electrocution if proper safety precautions are not observed.
WARNING
The washer is extremely heavy. Use caution when lifting and blocking the washer, and
do not allow unnecessary personnel in the immediate area while it is being moved.
Serious injury or death may result if safety precautions are not observed.
CAUTION
The washer is a large, heavy piece of machinery being moved out of a confined space.
Before removal and installation, remove or protect any equipment that might be damaged
by the washer on its way in or out.
NOTE
The washer is equipped with three shock absorbers.
1. Remove washer IAW procedures given in WP 0041 00.
2. Inspect shock absorbers (Figure 1, Item 1) for physical damage, fluid leakage, or loose bolts.
3. Install washer IAW procedures given in WP 0041 00.
