TM 10-3530-207-14
Table 4-2. Unit Troubleshooting
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
CABINET ASSEMBLY
1.
HOLDDOWN CLAMP ASSEMBLY LOOSE.
Step 1.
Check for loose, missing, or damaged hardware and clamp.
If hardware is missing or clamp is damaged, notify next higher level of maintenance.
Step 2.
Check for damaged trailer or cabinet assembly.
If trailer is damaged, refer to TM 9-2330-213-14.
If cabinet assembly is damaged, notify next higher level of maintenance.
2.
REAR DOOR OR ANY SIDE DOOR CANNOT BE OPENED.
Step 1.
Inspect door for dirty, cut, broken, or dented surfaces, broken welds, or a bad door gasket.
a.
Clean dirty surfaces with general purpose detergent (Appendix F, Item 11) and
water.
b.
Notify next higher level of maintenance for cut, broken, dented surfaces or welds,
and bad door gasket.
Step 2.
Check that handle lock is not bent, broken, loosely mounted or missing.
Notify next higher level of maintenance if any ofthe above conditions exist.
Step 3.
Check that door hinge is not broken or bent.
Notify next higher level of maintenance if any of the above conditions exist.
3.
REAR DOOR OR ANY SIDE DOOR DOES NOT CLOSE SECURELY.
Inspect door for the same defects as malfunction 2.
4-32
